P0202

TORQDEX // POWERTRAIN DTC

Injector Circuit Malfunction — Cylinder 2

An electrical fault has been detected in the fuel injector circuit for cylinder 2.

CODE FAMILY Powertrain
SEVERITY HIGH
DRIVEABILITY DRIVEABILITY MAY BE LIMITED
COMMON AREA Injector 2 / Wiring / PCM Driver

00 // CODE DEFINITION

What P0202 means

P0202 indicates an electrical problem in cylinder 2's fuel-injector circuit.

The injector, harness, connector, power feed, or control-module driver may be responsible.

01 // COMMON SYMPTOMS

What you may notice

Cylinder 2 misfire
Rough idle
Reduced power
Check-engine light
Poor fuel economy

02 // COMMON CAUSES

What can trigger P0202?

INJECTOR

Injector coil fault

The injector may be open, shorted, or outside normal resistance.

WIRING

Circuit damage

Open or shorted wiring can prevent injector control.

CONNECTOR

Poor terminal contact

Corrosion or loose pins can interrupt current.

03 // DRIVEABILITY

Can I keep driving with P0202?

SEVERITY HIGH
DRIVEABILITY MAY BE LIMITED

Use caution. A high-severity fault can affect engine, transmission, electrical, or emissions-system operation. If the vehicle is running poorly, overheating, losing oil pressure, flashing the check-engine light, or entering reduced-power mode, avoid continued driving until the cause is diagnosed.

04 // DIAGNOSTIC ORDER

Start here

01

Check for P0302

Confirm whether cylinder 2 also has a misfire fault.

02

Inspect injector wiring

Check the harness and connector.

03

Measure injector resistance

Compare cylinder 2 with specifications and neighboring injectors.

04

Verify injector command

Check injector power and control signal.

05 // COMMON REPAIR AREAS

Systems commonly involved

These are common areas associated with P0202. Testing should confirm the actual fault before parts are replaced.

INJECTOR

Injector coil fault

The injector may be open, shorted, or outside normal resistance.

WIRING

Circuit damage

Open or shorted wiring can prevent injector control.

CONNECTOR

Poor terminal contact

Corrosion or loose pins can interrupt current.

06 // DIAGNOSTIC PRINCIPLE

Confirm the fault before replacing parts

P0202 identifies a condition detected by the vehicle control system. It does not automatically identify one failed component. Test the affected system before replacing parts.

07 // RELATED TORQDEX DIAGNOSTICS

Related diagnostic guides

Continue troubleshooting by symptom and system. These TorqDex guides cover common diagnostic paths associated with this trouble code.

08 // RELATED CODES

Related trouble codes